Standard Default Parameters A - 3
Function Key Mapping Disable
7-19
Simulated Caps Lock Disable
7-20
Convert Case Disable
7-21
Wand Emulation Host Parameters
Wand Emulation Host Types
Symbol OmniLink Interface Controller
1
8-4
Leading Margin 80 msec
8-6
Polarity Bar High/Margin Low
8-8
Ignore Unknown Characters Transmit
8-9
Convert All Bar Codes to Code 39 Disable
8-10
Convert Code 39 to Full ASCII Disable
8-11
UPC/EAN
UPC-A Enable
9-5
UPC-E Enable
9-6
UPC-E1 Disable
9-7
EAN-8/JAN-8 Enable
9-8
EAN-13/JAN-13 Enable
9-8
Bookland EAN Disable
9-10
Decode UPC/EAN Supplementals (2 and 5
digits)
Ignore
9-11
Decode UPC/EAN Supplemental Redundancy 20
9-20
Transmit UPC-A Check Digit Transmit
9-21
Transmit UPC-E Check Digit Transmit
9-21
Transmit UPC-E1 Check Digit Transmit
9-21
UPC-A Preamble System Character
9-24
UPC-E Preamble System Character
9-26
UPC-E1 Preamble System Character
9-28
Convert UPC-E to A Disable
9-30
Convert UPC-E1 to A Disable
9-30
Table A-1
Standard Default Parameters Table (Continued)
Parameter Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
