TGA 2950 EGA Furnace Option
TA I
NSTRUMENTS
TGA 2950 D–11
Figure D.5
Plugging in the
AIR COOL Line
10. Press the FURNACE key to raise the
furnace carriage until the lower mounting
screws are below the top edge of the en-
larged cutout in the instrument faceplate.
Then press the STOP key.
11. Plug the EGA furnace arm into the connec-
tor on the carriage and tighten the lower two
mounting screws using the 3/32-inch ball
driver supplied with the TGA 2950 EGA.
See Figure D.6 on the next page.
Wire Ties
Water
Cool
Lines
Air
Cool
Line
To Next Page
Loading...
