TGA 2950 EGA Furnace Option
TA I
NSTRUMENTS
TGA 2950 D–13
Figure D.7
Tightening the
Upper Mounting Screws
13. Connect the purge hose to the gas purge
inlet on the right side of furnace.
Hold onto the glass purge tube with one hand
while you install the purge hose to avoid breaking
the glass.
14. Check the Heat Exchanger reservoir water
level and add water if needed. See Chapter
2 “Filling the Heat Exchanger” for instruc-
tions.
t
CAUTION:
To Next Page
Loading...
