80
To activate monitor:
1 Press the monitor function key to activate monitor and hear
any traffic on the channel.
Alternatively, long press
.
While monitor is on, the LED slowly flashes green and
appears in the display.
2 Press the monitor function key again to turn monitor off.
Alternatively, long press
.
Receiving a call in conventional mode
When there is valid activity on your radio’s currently selected
channel or group, the radio unmutes and you can hear the call.
Making a call in conventional mode
To make a call in conventional mode:
1 Select the required conventional channel ("Selecting a
conventional channel" on page 79).
2 Check that the channel is clear. If the LED is glowing green,
then the channel is busy and you may not be able to transmit.
3 Once the channel is clear (the LED no longer glows), hold the
radio so that the microphone is about one inch (2.5cm) from
your mouth.
4 Press and hold the PTT key to transmit.
CHAN
CONV109
To Next Page
Loading...
