MAINTENANCE
After First
50
Hours
(New
Machines Only)
10. Clean the filter installation surface on the
filter stand.
11
. Apply a thin layer
of
oil
to the packing
of
the new filter.
12.
Install the new filter by hand.
13.
Tighten one more turn after the filter
packing comes
in
contact with the
surface.
14. Supply
oil
up to the upper limit
(H)
of the
dipstick
(1).
Problems could arise if the
oil
level
is
either too low or too high.
15. Tighten the
oil
supply cap
(2)
.
16.
Lower the canopy.
17.
Start the engine,
run
it
at low idle for
about 3 minutes, then stop
it.
18.
After about 10 minutes, inspect the
oil
level.
126
To Next Page
Loading...
Need help?
General
