MAINTENANCE
After
First 50
Hours
(New
Machines
Only)
Replacing the Pilot Line Filter
AwARNING
• Stop the engine and
allow
the
machine
to
cool before performing
maintenance.
• Oil
may
spray
out
if
caps
or
filters are
removed
or
pipes disconnected before
releasing
the
pressure in
the
hydraulic
system.
• When removing plugs
or
screws
or
disconnecting hoses, stand
to
the
side and loosen slowly,
to
gradually
release
the
internal pressure before
removing.
1.
Tilt up the canopy.
Refer to page 153, "Tilting Up the
Canopy."
2.
Turn
the case
(1)
counterclockwise and
remove
it.
3.
Remove the element
(2)
and 0-ring
(3).
4.
Clean the inside of the case
(1
).
5.
Install the new element
in
the case
(1
).
6.
Install the new 0-ring, then tighten the
case
(1).
128
To Next Page
Loading...
Need help?
General
