OPERATION
Operating Procedures
Backfilling
With the bucket lowered, drive near the hole and tilt the front edge
of
the bucket downward
as soon as it passes over the near side
of
the hole. Raise the bucket and empty the load only
when necessary.
Leveling Operation using
the
Float position
AwARNING
•
Make
sure
the
bucket is lowered
to
the
ground before floating
the
lift arms. Floating
the
lift arms while they are raised will cause the bucket
to
fall rapidly and is dangerous.
•
Do
not
drive
the
loader forward with the lift arms
in
Float position.
T7
D041
1
Lower the bucket onto the ground, then put the lift arms
in
Float position. Tilt the bucket
forward
to
stand it on its cutting edge, then level the loose material while driving rearward.
Loading
Approach the truck and stop, then raise the bucket until its lower edge clears the truck bed.
Drive the loader slowly forward, stop at the position where the bucket
is
to
be tilted forward,
then tilt the bucket forward, releasing the material
in
the bucket into the truck bed. When the
truck is half loaded, use the bucket
to
spread the load evenly.
93
To Next Page
Loading...
Need help?
General
