OPERATION
Operating Procedures
Operations Possible with this Machine
IMPORTANT: Do not perform scooping or grading operations with the bucket cylinders
fully extended. The traction force will apply extremely heavy loads on the bucket
cylinders and this may damage them.
Scooping
T7D0371
Lower the lift arms and bring the bucket down to the ground with the front end tilted slightly
forward, then drive the loader forward until the bucket is filled with the material. Next tilt the
bucket rearward and scoop up the material.
Grading
T7D0381
Tilt the front edge
of
the bucket
down
at
an
angle that
is
appropriate for the ground hardness,
then drive the loader forward slowly, digging into the ground with the cutting edge
of
the
bucket. When the bucket
is
full, tilt it rearward.
Leveling
T7D0391
Raise the lift arms and tilt the bucket forward, then release it as the loader is driven forward.
Next tilt the bucket forward and lower the front edge until it
is
slightly above the ground surface,
then back the loader over the load that was just released.
92
To Next Page
Loading...
Need help?
General
