101
Model C606
Troubleshooting Guide
PROBLEM PAGE
REF.
REMEDYEITHER SIDE
PROBABLE CAUSE
SOFT SERVE SIDE
PROBABLE CAUSE
SHAKE SIDE
PROBABLE CAUSE
3. No product is
being
dispensed.
a. Low on mix. The MIX
OUT light is on.
a. Add mix to the mix
hopper. Return to AUTO
mode.
67 /
68
b. The power switch is
in the OFF position.
b. Place the power switch to
ON and select AUTO.
64
c. Machine not in AUTO
mode.
c. Select AUTO and allow
machine to cycle off
before drawing product.
68
d. Beater motor is out
on reset, BEATER
OVERLOAD
message displayed.
d. Call an authorized service
technician.
---
e. The pump motor is
not running in the
AUTO mode.
e. Push the pump reset
button. Check pump
motor is operating when
the draw valve is raised.
32
f. Freeze-up in mix inlet
hole.
f. Call an authorized service
technician.
---
g. The mix pump ball
crank is broken.
g. Call an authorized service
technician.
---
h. Feed tube or check
ring not properly
installed.
h. Make sure feed tube and
rubber check ring are
properly installed.
62
i. Menu is displayed
making flavor select
keys inoperative.
i. Exit the menu by moving
thecursorarrowto“EXIT”
and touching the CAL
symbol. This will restore
the control keys to their
normal function.
78
To Next Page
Loading...
