Taylor C606 - Page 109

103
Model C606
Troubleshooting Guide
PROBLEM PAGE
REF.
REMEDYEITHER SIDE
PROBABLE CAUSE
SOFT SERVE SIDE
PROBABLE CAUSE
SHAKE SIDE
PROBABLE CAUSE
6. The mix in
the hopper is too warm.
a. Hopper cover is not
in position.
a. Clean and sanitize hopper
cover and place in position.
68
b. The agitator is not
installed.
b. Clean and sanitize the
agitator and install.
65 /
67
c. The hopper
temperature is out of adjustment.
c. Call an authorized service
technician.
---
7. The mix in
the hopper is too cold.
a. The hopper
temperature is out of adjustment.
a. Call an authorized service
technician.
---
8. Mix Low and
Mix Out probes are not functioning.
a. Milkstone build-up in
the hopper.
a. Clean hoppers thoroughly.
92
9. Product is
collecting on top of the draw valve.
a. Inadequate
lubrication of spinner shaft or seal.
a. Lubricate properly.
53
b. Spinner shaft seal is
missing or worn.
b. Install or replace the
spinner shaft seal.
53
10. Product is
collecting on top of the freezer door.
a. The top o-ring on
draw valve is improperly lubricated or worn.
a. Lubricate properly or
replace the o-ring.
53 /
58
11. Excessive
mix leakage from the bottom of door spout.
a. Bottom o-ring on
draw valve is improperly lubricated or worn.
a. Lubricate properly or
replace the o-ring.
53 /
58