105
Model C606
Troubleshooting Guide
PROBLEM PAGE
REF.
REMEDYEITHER SIDE
PROBABLE CAUSE
SOFT SERVE SIDE
PROBABLE CAUSE
SHAKE SIDE
PROBABLE CAUSE
14. The freezing
cylinder walls
are scored.
a. Missing or worn front
bearing.
a. Install or replace the front
bearing.
55
b. Missing or worn front
bearing and beater
shoes.
b. Install or replace the front
bearing and beater shoes.
58
c. Damaged scraper
blades and/or clips.
c. Replace scraper blades
and/or clips.
57
d. Broken freezer door
baffle rod.
d. Replace freezer door.
59
e. Sanitizing solution
was still in the
freezing cylinder
when unit was placed
in AUTO.
e. Unit must NOT be placed
in AUTO during sanitizing.
Place in AUTO only after
unit has been primed and
all sanitizing solution has
been removed.
64 /
66
f. Broken beater pins. f. Replace beater assembly.
53 /
57
g. Beater assembly is
bent.
g. Replace beater assembly.
53 /
57
h. Gear box is out of
alignment.
h. Call an authorized service
technician.
---
15. The product
makes a
popping
sound when
drawn.
a. Draw rate is set too
fast.
a. Adjust draw rate of 5 to 7
1/2 oz. (142 g. to 213 g.)
of product by weight in 10
seconds.
59
b. Pump assembled
incorrectly.
b. Assemble and lubricate
according to instructions
in this manual.
60
c. Freezing cylinder not
primed correctly.
c. Drain the freezing cylinder
and reprime the machine.
67 /
68
To Next Page
Loading...
