Taylor C606 - Page 113

107
Model C606
Troubleshooting Guide
PROBLEM PAGE
REF.
REMEDYEITHER SIDE
PROBABLE CAUSE
SOFT SERVE SIDE
PROBABLE CAUSE
SHAKE SIDE
PROBABLE CAUSE
18. The draw
valve is not closing.
a. The draw valve was
not aligned with the actuator bracket when the freezer door was installed.
a. Reassemble with the
correct alignment. Tighten the handscrews in a criss-cross pattern when installing the freezer door.
55
b. The draw valve was
not lubricated.
b. Lubricate the draw valve
and o'rings.
53
c. The spinner shaft
was not lubricated.
c. Lubricate the spinner
shaft.
53
d. The spinner blade
became disengaged from the driven spinner when the draw valve was raised.
d. Call an authorized service
technician to check the spinner coupling position on the motor.
---
e. The product is too
thick.
e. Check that the product
temperature is within specification. (See problem “Product Too Thick” on page 102.)
---
f. The shake actuator
assembly is out of alignment or is malfunctioning.
f. Call an authorized service
technician.
---
19. The mix
pump will not operate in the PUMP mode.
a. Pump motor is not
running.
a. Push the pump reset
button.
32