Taylor C606 - Page 56

50
Model C606Important: To the Operator
120515
If the COOL phase data or “All phase data” were
reviewed, the final temperature zone sample in the
record will be displayed with the selection for the
result screen.
COOL RB r14 s42
20.0 5/15 04:15
> Result
Exit
Figure 92
Select the Calibration symbol
to view the Heat
Cycle results screen.
PASS r1 s43
Heat Cycle results
> Next record
Exit
Figure 93
To view the details for the same phase in the
preceding record (“Next record”), select the
Calibration symbol
. If “All phase data” was
selected, the record number will remain the same
and the next phase sample will be displayed.
HOLD LH r1 s16
158.7 5/15 04:15
> Next zone
Exit
Figure 94
Exit the record screens by moving the arrow to “Exit”
and select the Calibration symbol
.
The average heat treatment cycle will contain
approximately 40 samples of the four temperature
zone screens.
The SYSTEM INFORMATION is displayed on four
separate screens. The first screen contains the
control and software version installed in the
machine. (See Figure 95.)
SOFTWARE VERSION
C602 / C606 UVC
VERSION V01.01.00
> Next
Figure 95
Select the CALIBRATION symbol
to advance to
the next system information screen containing the
software language version. (See Figure 27.)
LANGUAGE
V3.00
English
> Next
Figure 96
For UVC4 models only, select the CALIBRATION
symbol
to advance to the third system
information screen containing the Boot loader
version. (See Figure 97.)
Boot loader
V1.13.000
> Next
Figure 97
Select the CALIBRATION symbol
to advance to
the last system information screen containing t he
model bill of material and machine serial number.
(See Figure 98.)
B.O.M. C60000000
S/N M0000000
> Next
Figure 98