66
5. Install the beater shoes. (See Figure 123.)
Figure 123
6. Slide the beater assembly the rest of the
way into the freezing cylinder.
Make sure the beater assembly is in
position over the drive shaft by turning the
beater slightly until the beater is properly
seated. When in position, the beater will
not protrude beyond the front of the
freezing cylinder. (See Figure 124.)
11250
Figure 124
7. Install the draw valve. Slide the 3 o -rings
into the grooves on the draw valve and
lubricate. (See Figure 125.)
10395
L
U
B
E
R
Figure 125
8. Lightly lubricate inside of the top of the
freezer door valve cavity.
(See Figure 126.)
Figure 126
Insert the draw valve from the top, with
the draw handle slot facing forward.
(See Figure 127.)
Figure 127
9. Assemble the freezer door. Place the door
gasket into the groove on the back of the
freezer door. Slide the front bearing over
the baffle rod so the flanged edge is
against the door. DO NOT lubricate the
gasket or bearing. (See Figure 128.)
Figure 128
Downloaded from www.dlmanuals.com
To Next Page
Loading...
