81
Change the time by touching the AUTO or
OPTIONAL FLAVOR symbol
with the
cursor under the hour position. Move the
cursor to the minutes by selecting the
CALIBRATION symbol
. Once the correct
minutes are entered, select the CALIBRATION
symbol
to advance the cursor to the month.
(See Figure 185.)
SET CLOCK
12
:01 08/15/2002
>Exit
Figure 185
Enter the correct month, day, and year. Then
select the CALIBRATION symbol
to
advance to the DAYLIGHT SAVING TIME
screen. (See Figure 186.)
DAYLIGHT SAVING TIME
ENABLED
> Enable
Disable
Figure 186
The Daylight Saving feature when enabled,
will automatically adjust the control clock for
daylight saving time. To Disable the Daylight
Saving Time feature, select the AUTO symbol
to move the arrow to Disable. Then touch
the CALIBRATION symbol
to save the new
setting.
The AUTO HEAT TIME screen allows the
Manager to set the time of day in which the
heat treatment cycle will start.
(See Figure 187.)
AUTO HEAT TIME
00:00
Change
>Exit
Figure 187
Note: Do not advance the Auto Heat Time
setting except on the day the unit is brush
cleaned. Increasing the time between heat
cycles will cause the machine to soft lock if the
start of the cycle does not begin within 24
hours from the start of the previous heat
treatment cycle.
To set the AUTO HEAT TIME select the AUTO
symbol
to move the arrow to Change. Then
select the CALIBRATION symbol
.The
screen will display the time with the cursor
under the hour position. (See Figure 188.)
AUTO HEAT TIME
00
:00
Figure 188
Select the AUTO symbol or the OPTIONAL
FLAVOR symbol
to increase or decrease
the hour to the desired setting. Then move the
cursor to the minutes position by selecting the
CALIBRATION symbol
. Adjust the setting
for minutes, then select the CALIBRATION
symbol
to save the setting and return to the
AUTO HEAT TIME screen. Select the
CALIBRATION symbol
to exit the screen
and return to the Menu.
The AUTO START TIME option allows the
Manager to set the time of day at which the
machine automatically enters the AUTO mode
from the STANDBY mode. The machine must
be in the STANDBY mode without a freezer
lock condition in order to AUTO start at the
programmable time. The AUTO START TIME
can also be Disabled and require starting the
AUTO mode manually. (See Figure 189.)
AUTO START TIME
DISABLED
Enable
> Disable
Figure 189
Downloaded from www.dlmanuals.com
To Next Page
Loading...
