82
Enable the AUTO START TIME by selecting
the AUTO symbol
to move the arrow up to
Enable. Select the CALIBRATION symbol
to advance to the next screen.
(See Figure 190.)
AUTO START TIME
00:00
Change
>Exit
Figure 190
Program the AUTO START TIME by selecting
the AUTO symbol
to move the arrow to
Change. Select the CALIBRATION symbol
to advance to the next screen.
(See Figure 191.)
AUTO START TIME
00
:00
Figure 191
Program the AUTO START TIME by
increasing (AUTO symbol
) or decreasing
(OPTIONAL FLAVOR symbol
) the hour
setting above the cursor. Select the
CALIBRATION symbol
to advance the
cursor and program the minutes setting.
Select the CALIBRATION symbol
to return
to the previous screen with the new time
setting displayed. Select the CALIBRATION
symbol
to exit the screen and return to the
Menu.
The STANDBY option is used to manually
place the left or right side in the standby mode
during long, no draw periods. Select the
STANDBY screen from the Menu. Select the
AUTO symbol
tomovethearrowuptothe
left (shake) or right (soft serve) side. Select
the CALIBRATION symbol
to activate
Standby for the selected side.
Repeat the steps to activate Standby on the
remaining side. (See Figure 192.)
STANDBY MODE
LEFT
RIGHT
> EXIT
Figure 192
Discontinue Standby operation for either side
by exiting the Manager’s Menu and select the
AUTO mode.
The BRUSH CLEAN CYCLE option allows the
Manager to select the maximum number of
days between brush cleaning the machine.
The brush clean cycle may only be changed
after the freezer has been manually cleaned
but before it has been placed in the AUTO or
STANDBY mode.
The following message will be displayed if the
BRUSH CLEAN CYCLE option is selected
when the machine is not in a brush clean
state. (See Figure 193.)
BRUSH CLEAN CYCLE
No Changes Allowed
Press any Key
Figure 193
Change the number of days between brush
clean intervals by selecting the AUTO symbol
to decrease the days or the OPTIONAL
FLAVOR symbol
to increase the number of
days. Select the CALIBRATION symbol
to
save the setting and exit back to the Menu.
The number of days displayed on the brush
clean counter will change to the new setting.
(See Figure 194.)
BRUSH CLEAN CYCLE
TIME 14 DAYS
Figure 194
Alwa ys comply with local guidelines on the
number of days allowed between brush clean
cycles.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
