Taylor McDonald's C602 - WIRING DIAGRAM; 3-Phase Wiring Diagram

95
Problem Shake Side
Probable Cause
Soft Serve Side
Probable Cause
Either Side
Probable Cause
Corrective Action
The draw valve is not closing.
The draw valve was not aligned with the actuator bracket when the freezer door was installed.
Reassemble with the correct alignment. Tighten the handscrews in a criss-cross pattern when installing the freezer door.
The draw valve was not lubricated.
Lubricate the draw valve and o’rings.
The spinner shaft was not lubricated.
Lubricate the spinner shaft.
The spinner blade became disengaged from the driven spinner when the draw valve was raised.
Call an authorized service technician to check the spinner coupling position on the motor.
The product is too thick.
Check that the product temperature is within specification. (See problem “Product Too Thick” on page 91.)
The shake actuator assembly is out of alignment or is malfunctioning.
Call an authorized service technician.
The mix pump will not operate in the PUMP mode.
Pump motor is not running.
Push the pump reset button.
The mix pump runs constantly in the AUTO mode.
Draw valve is not fully closed.
Raise draw handle so draw valve is closed all the way.
Downloaded from www.dlmanuals.com