28
Model PH90Operating Procedures
Step 13
Install the draw valve spinner assembly. Insert the
draw valve from the bottom until the slot in the draw
valve which accepts the draw handle comes into view.
Figure 22
Step 14
Install and lubricate the pivot pin o- ring.
Figure 23
Step 15
Install the draw handle. With the stopping tab of the
draw handle facing down, slide the fork of the draw
handle into the slot of the draw valve. Secure the draw
handle with the pivot pin.
Figure 24
Step 16
Lubricate the shaft of the spinner blade up to the
groove.
Figure 25
To Next Page
Loading...
