33
Command Mode - Saving and Replaying Command Scripts
You may have a sequence of commands that you commonly use or would be
helpful to have quick access to again in the future. In these cases you can SAVE
and RUN list of commands from the COMMAND MODE prompt. You can even
assign these commands to a new button in the PROGRAM menu for specific
locks! With this ability you can actually custom program your Phoenix tool.
Command scripts can also be exported and imported to the Phoenix using the
Phoenix Commander software (optional) allowing you to share your scripts with
other safe technicians.
Creating a new command script is a simple as entering COMMAND MODE and
entering ‘save’ following by the name you’d like to assign to the script and pressing
[OK]. You’ll then enter each command individually and instead of executing the
commands the Phoenix will save them to the indicated script. Once completed,
use the [X] button to exit COMMAND MODE and save your script. To run your
command at any point in the future, go to COMMAND MODE and enter ‘run’
followed by the script name.
Example Script - Adding User #2 with code 222222
To Next Page
Loading...
General