6
Important Notes and Recommendations
Disconnect all locks and keypads from Phoenix before powering on/off
Never connect Phoenix to any lock that has been drilled or damaged (including
water damage)
Use extreme caution if attempting to splice the Phoenix into keypad/lock cables.
An incorrect splice can damage both the Phoenix and the lock electronics.
For faster LaGard Resets, avoid charging via A/C during the reset process
During lock reset procedure, avoid touching or moving lock cable or tool. Leave
stationary until reset is complete to insure signal integrity
Remove batteries from all keypads before connecting to Phoenix except when
prompted otherwise
Observe orientation of tabs on keyed plugs before connecting
Hold “backup” pressure on Junction Box connectors when plugging in cables
Never allow powered JumpBox cable to come into contact with metal surfaces
such as the safe door or keypad housing
For proper functionality, wait until locks in penalty mode are no longer in lockout
before connecting them to the Phoenix
Never open Phoenix tool or remove cover while the unit is powered up
Never connect USB programing cable to the Phoenix will the tool is powered on.
Doing so can potentially damage your computer.
To Next Page
Loading...
General