Taiwan Biophotonic Corporation
33
Battery Charge
1. Unplug the anti-ESD (Electrostatic discharge) cover from
the micro USB AB port on the watch case.
2. Plug one end of the micro USB cable into the USB port of
the AC adaptor.
3. Plug the other end of the micro USB cable into the micro
USB AB port of your oCare
TM
Pro 100 as illustrated in
Figure 3.
4. While in charging, LED INDICATOR:
flashes WHITE every 5 seconds to indicate charging
status;
stays WHITE (constant ON) to indicate battery full
status.
5. If the battery of your oCare
TM
Pro 100 is completely
drained, it takes roughly 3 hours to fully charge the device.
While in charging, the LED INDICATOR will not active
and the Battery Symbol will not display.
6. Plug the anti-ESD cover back to the micro USB AB port.
To Next Page
Loading...