6. PROGRAMMING OPERATIONS EO1-11152
6.7 PLU Table Programming (Submode 4)
6-30
6.7.3 PLU Programmed Data Copying
This operation is used to copy the programmed data of a PLU item and to use it in programming another PLU
item, thus eliminating time in PLU programming operation.
To program new PLUs or to change any programmed contents of PLUs:
Any time outside a sale (except the following case)
To change the PLU of the copy-destination with sales data not zero:
After PLU Reset
4 [X] |PLU Code of the copy-destination
| [PLU] [NS]
|PLU Code of the copy-source
| [PLU]
The programmed data of the copy-source PLU is now copied to the copy-destination
PLU (except the PLU Code). Then follow the procedure in Section 6.7.1
Programming or Changing to change data of any required Addresses.
Example) To program PLU 90701 (Drink Small-B) again that was once programmed and then deleted, by
copying the programmed data of PLU 90601 (Drink Small-A):
Key Operation
Mode Lock: SET, enter 4, depress the [X] key.
90701 [PLU] (PLU Code of the copy-destination)
[NS]
90601 [PLU] (PLU Code of the copy-source)
2 [ST] (Address 2, Name changed into: Drink Small-A)
404 [#] (D)
702 [#] (r)
609 [#] (i)
614 [#] (n)
611 [#] (k)
[#] (Space)
503 [#] (S)
613 [#] (m)
601 [#] (a)
612 [#] (l)
612 [#] (l)
213 [#] (-)
402 [#] (B)
[ST]
9 [ST] 7 [#] (Address 9, PLU Group No. changed into: 7)
[AT/TL] (to complete this submode)
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
08-22-2003 FRI #0
P04
090701
Drink Small-A
#00 090601
#02 Drink Small-B
#00 07
00000
00003
0033 14:49TM
OPERATION
CONDITION
To Next Page
Loading...
Need help?
General
