6. PROGRAMMING OPERATIONS EO1-11152
6.15 PLU Preset-Code Key Setting (Submode 27)
6-40
6.15 PLU Preset-Code Key Setting (Submode 27)
When there are any keys programmed as PLU Preset-code Keys on the ECR Keyboard (Ordinary or Flat Type),
and/or when the PLU Keyboard PK-2 (hardware option) is connected to the ECR, a PLU code may be preset to
each of those keys in this operation.
Any time outside a sale
Mode Lock: SET
Barcode Scanning
27 [X] | PLU Code
| [KEY] [AT/TL]
NOTES: 1. If the PLU Code entry is skipped and a [KEY] is simply depressed in the above sequence, the
preprogrammed PLU Code of the KEY will be displayed.
2. A non-opened PLU Code (i.e. PLU non-existent in the PLU table file) can be set on a KEY;
however, pressing the KEY in sale entries will result in an error unless the code is opened in the
PLU TABLE PROGRAMMING operation, Submode 4.
3. If “0” is entered as PLU Code in the above sequence, the KEY will be closed. Pressing the closed
KEY in sale entry will cause an error.
Example) To set following PLU Codes to KEYs on the ECR keyboard:
Mode Lock to SET
27 [X]
PLU Code
50321 50321 [required key]
50322 50322 [required key]
[AT/TL]
Repeat for other keys.
Enter through Numeric Keys
on the ECR Keyboard
(Enter 0 to close the key);
Max. 6 or 13 digits
on the PK-2 keyboard.
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
08-25-2003 MON #0
P27
#073 050321
#074 050322
0054 13:51TM
Location Code (left side); refer to REMARKS 1 and 2 on the next page.
PLU code assigned to the key (right side)
OPERATION
CONDITION
To Next Page
Loading...
Need help?
General
