7. DEPARTMENT AND PLU MAINTENANCE EO1-11152
7.3 PLU Price Changing with DLL (Submode 73)
7- 4
7.3 PLU Price Changing with DLL (Submode 73)
This submode is used to change prices of PLUs existent in the PLU Table files, and into immediately load the
data into Satellite Terminals.
Any time outside a sale for Master or Satellite.
(only when the feature “PLU not to be inquired” is selected)
Mode Lock: SET and IN-LINE Lamp illuminated
Barcode Scanning Can be skipped (for non-split Pricing type
or when Whole Package Quantity is 1.)
73 [@/FOR] | PLU code
| [PLU] | New Whole Package Quantity | [ST]
Max. 2 digits; 0 to 99
| New Preset Price
| [#] [AT/TL]
Max. 6 digits; 0 to 999999
(result: $0.00 to $9999.99)
to make open-price PLU
Repeat for other PLUs
NOTES: 1. When the [AT/TL] key is depressed in the above operation, it sends a DLL-start command to the
designated terminals.
2. A maximum of 100 PLUs’ prices can be changed in one operation sequence of this submode.
3. When zero is entered as the New Preset Price value, the PLU is set with a zero price. When the
New Preset Price entry is skipped and the [#] is simply depressed, it will be an open-price PLU.
OPERATION
CONDITION
Repeatable from here for
PLU codes.
To Next Page
Loading...
Need help?
General
