7. DEPARTMENT AND PLU MAINTENANCE EO1-11152
7.2 Department Preset Price Setting or Changing with DLL (Submode 72)
7- 3
Deletion
The sales data of the required PLUs are zero and all terminals are outside a sale,
programming, or report taking operations. (when the feature “PLU not to be inquired”
is selected.)
The sale data of the required PLUs are zero and any time outside a sale for Master.
(when the feature “PLU to be inquired” is selected)
Mode Lock: SET and IN-LINE Lamp illuminated
63 [@/FOR] [ITEM CORR] | PLU code
| [PLU] [ST] [AT/TL]
Repeatable for other PLUs to be deleted.
NOTES: 1. Up to 100 PLUs can be added/changed/deleted once.
2. The DLL is possible while a sales transaction is being performed in the Satellite Terminal.
7.2 Department Preset Price Setting or Changing with DLL (Submode 72)
This submode is used to newly set or change a preset price to required departments, and loads the price data
into Satellite Terminals.
Any time outside a sale
Mode Lock: SET and IN-LINE Lamp illuminated
| New Preset Price
| [DEPT]
Max. 6 digits; 0 to 999999 (Department Preset Code Key)
(result: $0.00 to $9999.99)
72 [@/FOR] [AT/TL]
| Dept. Code
| [DP#] | New Preset Price | [#]
Max. 2 digits; 1 to 99 Max. 6 digits; 0 to 999999
* (result: $0.00 to $9999.99)
Repeatable for other departments * For sequentially programming the department,
the Dept Code specification can be skipped.
NOTES: 1. When the [AT/TL] key is depressed in the above operation, it sends a DLL-start command to the
designated terminals, makes the terminals HOLD condition, and executes DLL. After DLL is
completed, it sends a DLL-end command to each terminal and releases the HOLD condition.
2. When zero is entered as the New Preset Price value, the department is set with a zero price.
When the new Preset Price entry is skipped and the [DEPT] or [#] is simply depressed, it will be
an open-price department.
OPERATION
CONDITION
OPERATION
CONDITION
To Next Page
Loading...
Need help?
General
