32
TROUBLESHOOTING:
The distance measurements are off
This situation could arise because of the following
conditions:
• Have you properly set up your personal
profile?
Although the Accelerator comes with a pre-
programmed profile, a you will achieve much
greater accuracy by taking the 5 minutes to set a
personal profile
• Have you properly adjusted the pedometer
settings?
You may need to adjust the sensitivity or sleep
timer to better match your personal stride
characteristics and schedule
• Do you exhibit drastic variations in your
running/walking pace, or does your exercise
pace differ from the pace you used to
determine your stride length?
Accelerators work best when you maintain a
relatively steady running or walking pace.
Although your watch can readily differentiate
between running and walking, it is important
that when you determine your stride
lengths that you mimic the actual stride
and vigor you exhibit when exercising
I can't get rid of Dual Time!
HOLD ST/STP FOR 3 SECONDS to return
the Dual Time view to Home Time view.
Refer to the instructions in the Main
Functions Mode; Dual Time View page 5
The Exercise Mode keeps turning off.
Exercise Mode will automatically shut off
to conserve battery power. You can alter
the frequency of the auto shut off by
adjusting the sleep timer (1-240min).
Follow the instructions in Pedometer
Setting: 4 of 11 in the Main Settings
Menu or 4 of 5 in the Exercise Mode
Settings Menu
The Heart Rate doesn't read or is too
slow
• Make sure you allow Exercise Mode
to initialize before beginning exercise.
The watch will beep when it's ready.
Beginning exercise too quickly after
To Next Page
Loading...
