Note:
1. Do not use the port value such as 0-1024, 37780-37880, 1900, 3800, 5000, 5050, 9999,
37776, 39999 and 42323 since they are used as the special port.
2. When setting the port value, it's not recommended to use other ports' default port value.
B: PPPoE (Only TX-67)
PPPoE is to set a connection to the Internet with the account you get from the ISP. View
the IP address in the TCP/IP option if your setup is proper.
C: DDNS
The DDNS is to set to connect the various servers so that access the system via the server.
Go to the corresponding service website to apply a domain name and then access the
system via the domain. It works when also your IP address has changed
D: IP Filter
Trusted Sites: Only the IP listed below can login the device. Once you check the Trusted
Sites function, only the IP listed in the trusted sites list can login the specified device. All the
users can login the device if you do not check the trusted sites box here. The device IP
cannot list in the trusted list.
The MAC verification can only be valid when the device IP and the PC IP are in the same
IP segment.
E: SMTP (Email)
Fill in all the needed Information. You find them by searching your e-mail provider.
This function allows the system to automatically send out the test information to check the
email connection is proper or not. You need to check the box here to enable this function
and set the update period.
F: UPnP
Use the UPnP protocol to establish a forwarding relationship. The camera port is the
internal port and the router port is the external port. Access the external port to visit the IP
camera.
G: SNMP (Only TX-67)
SNMP is an abbreviation of Simple Network Management Protocol. It provides the basic
network management frame of the network management system. The SNMP widely used in
many environments. It is used in many network device, software and system.
To Next Page
Loading...
Need help?
General
