It is for the In area option in the Detect action list item. Here is to set the
min time between the target in the zone and an alarm activation
occurrence.
It is for the In area option in the Detect action list item. It is to set alarm
period. System just alarms once if the value is 0 here.
Check the box here to enable this function and then click button ，
you can set the target filter model in this scene. Click the button ，
you can remove selected target filter model.
6.6.2.3.3 Alarm Activation Setup
Alarm activation setup is shown as in Figure 6-10.
Figure 6-10
Here you can set rule arm and disarm period. Please click the Setup
button to set.
Check the box here so that the device can record when alarm
activation occurred.
Check the box here so that the device can send out an email when
alarm activation occurred.
Please note current function is null when the device is offline, or IP
conflict occurred.
Check the box here so that the device can snapshot when alarm
activation occurred.
Select a rule name from the dropdown list and then click
button; you can copy the alarm activation setup of current rule to the
selected rule.
To Next Page
Loading...
