Technaxx TX-65 - Destination; D: Nas; Record Control; A: Path

47
6.6.6.2 Destination
A: Path
Check the box here to storage the corresponding record or snapshot picture. There is local
MicroSD card, FTP or NAS storage setup for you to choose. Save the settings.
B: MicroSD card (Local)
Under local you can see:
 Device name: The name given to the MicroSd card slot.
 Status: Status of the storage device (MicroSD card).
 Attribute: Set the option for the MicroSD card read only or read & write.
 Used / Total Capacity: See the used and toal space of the MicroSD card in MB.
 Format: Click this button to format the MicroSD card. This will delete all saved files on
the MicroSD card.
C: FTP
First enable the check box for FTP under Path. Check the box to enable the FTP-server.
 Server Address: Enter the server address of the FTP-server
 Port: Server port of the FTP-server (0-65535)
 User Name: Optional
 Password: This can be empty when no user name is given.
 Remote Directory: This is the directory where the recorded files will be saved.
 Emergency (Local): In case FTP-server is not working the recorded files will be saved
local (MicroSD card).
D: NAS
First enable the check box for NAS under Path. Check the box to enable the NAS-server.
 Server Address: Enter the server address of the NAS-server
 Remote Directory: This is the directory where the recorded files will be saved.
6.6.6.3 Record control
Select Auto/Manual/Off mode. Manual mode is to begin record and auto mode is to record
in the specified period.
 Pack Duration: Defines the length of the file to be recorded (1-120 minutes).
 Pre-event Record: The time before the event is going to be recorded (0-5 seconds).
 Disk Full: When the MicroSD card is full then the system will stop or overwrite the
recording.
 Record Stream: Choose between Main or Sub Stream.