6.6.2.4 Parameter
The parameter interface is shown as in Figure 6-11.
Figure 6-11
Please select a scene from the dropdown list you want to set.
There are three modes: compromise mode, omission detect less and
error detect less.
The level ranges from 1 to 10. The default setup is 5. The higher the
sensitivity is, the easier for the device to detect the low contrast object
and small object. At the same time, the error detect may become more.
Click button , you can draw a detection zone.
Click button ，you can draw the privacy mask (shield) zone.
6.6.3 Network
6.6.3.1 TCP/IP
A: TCP/IP
TCP/IP mode is to set device login IP. It supports IPv4 and IPv6. IPv4 supports static IP
and DHCP, IPv6 only supports static IP. After you set the IP address manually, Web
interface can automatically go to the login interface of the new IP.
B: P2P/Easy4ip
If P2P/Easy4ip is enabled and the camera is configured over LAN/WiFi, it is possible to
connect the camera via the P2P function of the My Secure Pro app.
To Next Page
Loading...
Need help?
General
