Input your
IP address
here
6. Web Operation
This series network camera products support the Web access and management via PC.
Web includes several modules: Monitor channel preview, system configuration, alarm, etc.
6.1 Network Connection
Follow the steps listed below for network connection.
Make sure the network camera has connected to the network properly.
Set the IP address, subnet mask and gateway of the PC and the network camera
respectively. Network camera default IP address is 192.168.1.108. Subnet mask is
255.255.255.0. Gateway is 192.168.1.1
Use order ping ***.***.***.***(* network camera address) to check connection is OK or
not.
6.2 Login and Main Interface
Open IE/ Mozilla (Chrome/Safari optional) and input network camera address in the
address bar. See Figure 6- 1.
Figure 6- 1
Figure 6- 2
The login interface is shown on Figure 6-
2.
Input your user name and password.
Default factory name is admin and
password is admin.
Note: For security reasons, modify
your password after you first login.
To Next Page
Loading...
Need help?
General
