3 ACCESS BY WEBSERVER
You can get access to the Webserver by connecting the device via the 1000BASE-T-
Port (RJ-45) to your PC. Here the IP address of the device is dependent on the status
of the rotary switch (see CHAPTER 2.2.1)
Or you get access to the Webserver by the 100BASE-T1 Port to the Microcontroller and
the default IP address 192.168.0.49. The default configuration of this port is as
100BASE-T1-slave.
1. Please go to the networkadapter settings and adjust the IP in the same range of
your CM_CAN_Combo, dependent on which port you are connected to.
2. Enter the IP Address in your standard web browser. For more information about the
IP addresses see CHAPTER 2.2.1 and CHAPTER 4.3.
Note: Chrome or Firefox are recommended.
3. The following website should appear
Figure 3-1: Home Screen CM_CAN_Combo
To Next Page
Loading...