1 GENERAL INFORMATION
1.1 Functionality and Features of the CM_CAN_Combo
Figure 1-1: Capture_Module_CAN_Combo
The Technica Engineering Capture Module CAN Combo is used to capture the traffic
from the conventional CAN busses, as well as CAN-FD, FlexRay and RS-232 can be
captured without interfering the original networks.
Several devices can be used on the same setup, whenever more interfaces are needed,
and when other IVN technologies are present, the in-built-synchronization using
802.1AS allows for simultaneous use with the other “IVN2Eth Capture Modules”.
To Next Page
Loading...