Technica Engineering CM CAN Combo - System Information Tab

CM CAN Combo User Manual
20
4.3 System Information tab
4.3.1 General Information
Figure 4-3: System Information tab
On the “System Information“ tab some status information about the device is
displayed. You can check the version number of the application firmware and the
bootloader. The version number registers of the switch and PHY chips are displayed
for information. If these registers are displayed in red and as “FFFFFFFF”, this
port/PHY is defect.
Rotary switch: The configuration of the rotary switch is displayed here.
Hardware version: The version of your hardware of the CM_CAN_Combo is displayed
here.
MAX10 version: The version of your MAX10 Software of the CM_CAN_Combo is
displayed here.
FPGA version: The version of your FPGA Software of the CM_CAN_Combo is displayed
here.
Application Software version: The current firmware version of your CM_CAN_Combo
is displayed here.