4.4.6 Sleep Timeout
Figure 4-12: Sleep Timeout
Here you define the time in seconds, which has to go by with no communication on the
supervised ports before the CM_CAN_Combo falls asleep or enters the standby mode.
Reasonable values are between 15s and 300s.
4.4.7 Date and Time
Figure 4-13: Date and Time
By this field you can set the time of the Capture Module in shown format for the
timestamp in the TECMP-protocol.
Just type the date and time in the format as follows: YYYY-MM-DDThh:mm:ss
After typing please press
To Next Page
Loading...