4.5.3 100BASE-T1 Port
This is the second 100BASE-T1 Port in MQS-Connector (PIN 6 and 7) on the frontside
of the device
Figure 4-21: 100BASE-T1 Port
Port name: Port name of 100BASE-T1 Port can be changed.
BroadR-Reach® mode: Master/Slave Configuration of the 100BASE-T1 Port can be
changed
Keep Awake Reason Bus:
This port is supervised. If on this port is communication, CM_CAN_Combo can’t
go asleep.
This port is not supervised. The Capture Module can fall asleep even there is
communication on this port.
Working as Config-port (Default: GB-A):
You can configure the Capture Module when connected on this port with your
configuration PC and you get access to the webserver on this port.
To Next Page
Loading...