4.5.1 Spy multiplexer
You get access to the SPY multiplexer by clicking on “Spy”. Here you can set general
logging parameters and get an overview of set filters on each port.
Figure 4-15: Spy multiplexer
4.5.1.1 EtherType
Here you can choose the ethertype of the TECMP header. Please find more information
about the TECM Protocol in Chapter 6
TECMP [0x99FE]: The header of each logged frame gets the ethertype 0x99FE and the
header is a TECMP header
Legacy Mode [0x2090]: The header gets the ethertype 0x2090. The protocol is very
similar. Some fields have a different name but in general, the functionality is the same.
To Next Page
Loading...