4.5.2 Host Port
This is the first 100BASE-T1 Port in MQS-Connector (PIN 9 and 10) on the frontside of
the device.
Figure 4-20: Host Port
Port name: Port name of Host can be changed
BroadR-Reach® mode: Master/Slave Configuration of Host Port can be changed
Keep Awake Reason Bus:
This port is supervised. If on this port is communication, CM_CAN_Combo can’t
fall asleep or change into standby mode
This port is not supervised. The Capture Module can fall asleep even there is
communication on this port.
To Next Page
Loading...