4.5.5 CAN Ports
Figure 4-23: CAN-Ports
Port name: Port name of every CAN-Port can be changed.
Output to: Here you can define the logging port of the incoming traffic on this port.
• None: no logging port defined => no logging possible
• GB-A: GB-A is defined as logging port => logging with GB-A port is possible.
• 100Base-T1: 100Base-T1 is defined as logging port => logging with 100BASE-T1
port is possible.
CAN Type: Choose the different CAN Types:
• CAN 2.0
• Non ISO CAN-FD
• ISO CAN FD
CAN Mode: Choose the CAN mode:
• Passive Node (No ACK)
• Active Node (ACK)
Bit rate: Choose the bit rate which depends on the CAN-Bus.
To Next Page
Loading...