Working as Status Messages Port (Default: GB-A):
The status messages of the Capture Module are transmitted on this port. (for
details have look to Chapter 6)
The status messages of the Capture Module are not transmitted on this port,
except no other port is configured as status message port
Working as Control Message Port:
Incoming control messages for the Capture Module are redirected to the CPU of
the Capture Module (for details have look to Chapter 6)
Incoming control messages for the Capture Module are not redirected to the CPU
of the Capture Module.
Keep Awake Reason Bus:
This port is supervised. If on this port is communication, CM_CAN_Combo can’t
go asleep.
This port is not supervised. The Capture Module can fall asleep even there is
communication on this port.
Cascade to:
None: no forwarding of incoming traffic
100Base-T1: forwarding of incoming traffic to 100Base-T1
Note: in case of forwarding to 100BASE-T1, please be aware: you are forwarding
traffic from a 1Gbit/s-port to 100mbit/s-port.
802.1AS mode:
Disabled: there is no synchronisation with other PTP-partners
Bridge Slave: the connected device on this port must be a bridge master of PTP-
protocol
Bridge Master: the connected device on this port must be a bridge slave of PTP-
protocol
802.1AS Master: This port is generating the master clock for the logging system
Note: Ports configured as Bridge-Master or Bridge-Slave can be cascaded as well
CAN(FD) and Flexray and RS232 Inputs:
This is a table which shows all CAN, Flexray and RS232 ports and if the logging-
configuration of each port is linked to this 100BASE-T1-port.
CAN-A: CAN-A sends its logged information to this 100BASE-T1-port
CAN-A: CAN-A does not send its logged information to this 100BASE-T1-port
To Next Page
Loading...