Note: If no time is set, the time starts from powerup with default values
Note: If device is shut down by power reset or fell into status “Sleep”, “Date and
Time”-settings are lost and set to default when powering up.
Note: It makes sense to set the time if there is no PTP bridge master connected to
the Capture Module, to have a timestamp near the real time. Otherwise it will be the
difference from 01.01.1970 00:00:00.
4.5 Switch Status Tab
Figure 4-14: Switch Status tab
This is an overview of all ports. A blue bar indicates the linkup status on this port.
If you select a port or any other part of the CM_CAN_Combo, it is shown by blue text
of the selected part.
To Next Page
Loading...