CanIdReq/FlxSlot: It is the requested ID from the master for CAN or Flexray
Offset/ Repetition: Offset must be smaller than repetition. Only for Flexray.
Tx Timeout[ms]: it is in [ms] how often the request message should be sent, if it is not
provided by A2L-File.
JsonFile: here you can browse the *.json-file.
4.7 Control Message Triggers tab
4.7.1 User Interface
Figure 4-31: UserEvent Triggers Tab
On this tabulator an overview of all configured User Events is shown.
By pressing Edit Table the following user interface is shown:
Close Edit: go back to overview
Clear table: erase all entries
Add new entry: create and define a new entry
in overview of User Events. For specific and
allowed values, please see documentation of
the TECMP.
Apply: Here you can apply made changes of
the list. To make the changes permanent,
please save the configuration.
4.7.2 Values of Control Message Entries
Control Message-ID: Arbitrary decimal value from 1 to 255
To Next Page
Loading...