Figure 4-18: User interface basic filter (Add new entry)
Bus: Here can be defined the CAN-Port, to which the filter is applied.
Note: For other Busses than CAN no Filter is available
Parameter to filter: One “Parameters to filter” can be set right now. It is CAN_ID.
Note: Each “Bus” – “Parameter to filter” pair is possible for three times
Value: One value in defined format must be typed in this field
CAN_ID: Hexadecimal, e.g. “1FB”
Action: only one action is available
DROP: Each message that matches the Filter Entry will not be mirrored to
the logging port. It will be dropped.
To Next Page
Loading...