4.3 System Information tab
4.3.1 General Information
Figure 4-3: System Information tab
On the “System Information“ tab some status information about the device is
displayed. You can check the version number of the application firmware and the
bootloader. You see the configured IP-addresses. The version number registers of the
switch and PHY chips are displayed for information. If these registers are displayed as
“FFFFFFFF”, this port/PHY is defect.
Rotary Switch: The configuration of the Rotary switch is displayed here.
Hardware version: The version of your hardware of the CM_Eth_Combo is displayed
here.
Application Software version: The current firmware version of your CM_Eth_Combo is
displayed here.
To Next Page
Loading...