Field: Here you can define, what you want to filter:
Field: no specific value, it must be changed
Destination MAC: XX:XX:XX:XX:XX
Source MAC: XX:XX:XX:XX:XX
Outer VLAN: XXX[hex]
Inner VLAN: XXX[hex]
Ethernet Type: [2 bytes]: XXXX[hex]
IP-Msg Src IPv4: XXX.XXX.XXX.XXX
IP-Msg Dest IPv4: XXX.XXX.XXX.XXX
Source UDP Port: XXXX[hex]
Destination UDP Port: XXXX[hex]
ARP Sender IP: XXX.XXX.XXX.XXX
ARP Target IP: XXX.XXX.XXX.XXX
Subtype AVTP [1 bye]: XX[hex]
Stream ID AVTP [8 bytes]: XXXXXXXXXXXXXXXX[hex]
Value: Here you define the value of your Field. Allowed values depend on the chosen
Field.
How to use Advance Filter:
Please see CHAPTER 4.7.
4.5.2 Host Port
This is the 100BASE-T1 Port in the MQS-Connector on the frontside of the device.
Figure 4-20: Host Port
To Next Page
Loading...