4.5.1 Spy multiplexer
You get access to the SPY multiplexer by clicking on Spy. Here you can set general
logging parameters and get an overview of set filters on each port.
Figure 4-15: Spy multiplexer Overview (no Filters set)
4.5.1.1 Use PLP header
PLP-protocol is activated, and logged data is encapsulated in a new ethernet
frame with the original captured ethernet frame as payload.
PLP-protocol is deactivated, and logged data is sent to the logging port without
encapsulation.
4.5.1.2 Enable Traffic Shaping and Traffic Bandwidth
Traffic Shaping is enabled. It is possible to set a maximum Traffic Bandwidth, the
data is sent on the configured logging port.
Traffic Shaping is deactivated, and no Traffic Bandwidth is configurable. The data
will be sent as fast as possible.
To Next Page
Loading...