Bootloader version: The current bootloader version of your CM_Eth_Combo is
displayed here.
Controller IP address: The Current configured IP-address of the 100BASE-T1 port on
the Frontside is displayed here.
HW-IP address: The current IP-address of the configuration port (RJ-45 Port) is
displayed here.
Serial number: The Serial number of the CM_Eth_Combo is displayed here.
4.3.2 IP-addresses
Figure 4-4: IP-addresses
There are two possibilities to access to the device:
• Access by 100BASE-T1 port of the power connector at the frontside
• Access by the GB-Port which is activated as configuration port. By default, it is
GB-A
Controller IP address: This is the IP address you get access to the Webserver by the
100BASE-T1 port. This IP-address can be changed here. Please type the new IP-
To Next Page
Loading...