EasyManuals Logo

Technica Engineering IVN2Eth User Manual

Default Icon
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
CM Eth Combo User Manual
43
Keep Awake Reason Bus:
This port is supervised. If on this port is communication, CM_Eth_Combo can’t go
asleep.
This port is not supervised. The Capture Module can fall asleep even there is
communication on this port.
Section: It is a hexadecimal number. E.G “1A8”
It is a number assigned to any port separately. For further information see definition
of PLP-protocol. This value is used as VLAN-ID for the function Use OuterVlans in
CHAPTER 4.5.1.4.
BusID: It is a hexadecimal number. E.G “B0”
It is a number assigned to this port and the paired port (A is paired with B). For further
information see definition of PLP-protocol.
Enable Injection for this port:
If activate this function, you get access to a device directly connected on this
1000BASE-T1 Port by a GB-Port. After activating please apply the IP-address of the
connected device in the field “IP for Injection.
Note: Don’t forget to set “IP for Injection” on the specific GB-Port.
Note: Don’t forget to configure the field “Maximal delay (bytes) for Injection
No Injection possible on this port
IP for Injection: This field is available if the box Enable Injection for this port is
checked. Please fill in the IP-Address of the device directly connected on this port and
you want to get direct access by the GB-port.
Maximal delay (bytes) for Injection:
This field is available if the box Enable Injection for this port” is checked. Please fill in
a value many times higher than 512. The maximum is 1536 bytes. For higher
performance a small value is recommended.
This value is the maximum size of the possible inject frame, which is sent by the device
connected on the configured “Output to” GB-port.
Time Stamp: Timestamp in nano seconds [ns] resolution and accuracy of 40 nano
seconds [ns]
Messages Received: Counter for received messages on this port from the connected
1000BASE-T1-device
Messages with Error: Counter for received messages on this port from the connected
1000BASE-T1-device containing an error. For example, CRC errors.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Technica Engineering IVN2Eth and is the answer not in the manual?

Technica Engineering IVN2Eth Specifications

General IconGeneral
BrandTechnica Engineering
ModelIVN2Eth
CategoryControl Unit
LanguageEnglish

Related product manuals