Technica Engineering IVN2Eth - Page 48

CM Eth Combo User Manual
48
The GB-A-Port is configured as follows:
The important point here is the field IP for
Injection. Here must be the IP-Address of the
injecting device.
Also Working as DLT-port must be activated.
The BR1B-port is configured as follows:
Here, the important point is the field IP for
Injection. It must be the IP-Address of the
DUT_2. Of course the Box Enable Injection
for this port must be checked and the
Maximal delay (bytes) for Injection must be
filled out (512, 1024 or max. 1536).
If you have enabled the PLP Header for logging ports (see CHAPTER 4.5.1.1) filters are
needed:
For this example, the filters look like this:
The Filter must remove the PLP-header, if the
used protocol is bidirectional like for example
TCP.
Figure 4-29: Example for IP Injection
Figure 4-30: Example for IP Injection
Figure 4-28: Example for IP Injection