Technicolor TD5130 - Page 42

42
SETUP & USER GUIDE
Copyright © 2012 Technicolor. All rights reserved.
DMS-CTC-20120508-0000 v1.0.
To Set up MAC Filter
1 Click Home Network > Interfaces > WLAN to open the Wireless Access Point page.
2 Click Configure on the upper-right corner of the screen.
3 Under the MAC Filter section, MAC address field, type the MAC address of a device to add to the
MAC filter.
4 Click Add. The MAC address is displayed on the MAC List table below. Repeat step 3 and 4 to add
more MAC addresses.
5 On Restrict Mode, select the restriction mode:

Disable — To disable the MAC filter.

Deny — To deny Internet access to devices with MAC address listed on the MAC List table.

Allow — To allow Internet access only to devices with MAC address listed on the MAC List table.
6 Click Apply to save changes.Appendix